hi guys,

just checking if any 1 had encounter this problems before.

i was using a spektrum pro Rx sr3001 with futaba 3003 servo,

its use to be ok no problem, but lately, i notice the the servo was unable to get back to its center position, it will take some time to get back like 2 - 3 seconds. which means 1 lap you can get a straight line , 2nd lap you wont get straight line...

i have cross check with other 3 servo (3003) same problem, but if use KO propo servo, the servo will work fine....

i even tested with other spektrum Rx, same problem with futaba servo but no problem with KO servos...