R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 06-21-2009 | 01:51 PM
  #7338  
mattwoodcraft's Avatar
mattwoodcraft
Tech Elite
iTrader: (10)
 
Joined: Jul 2004
Posts: 2,747
From: perth / australia
Default

befor you even think of tuning your engine make sure it is warm at least half tank op temp then start to tune see if that helps at all read MM web sight its good source of info on tuning mate but start with your low needle first and start again reset all your needles flush
mattwoodcraft is offline