R/C Tech Forums - View Single Post - Xray NT1
Thread: Xray NT1
View Single Post
Old 06-18-2009, 07:57 PM
  #4208  
magee
Tech Apprentice
 
magee's Avatar
 
Join Date: Oct 2008
Posts: 50
Default second gear

mrod did you try the new 09 v2 gear its wider i had the same problem until i change to the v2 gear i remved first gear push the engine far back as i could get it , it was a litle tight then i put first back on ran it slow to break them in and no problem sofar, my luck next time i race it, ill strip it but its been good for about three races try it thanks ps also watch your second gear clutch you may half to sand it round again after while it get flat spots and hiting to hard after sanding, it will shift smooth into second hope it works for you thanks
magee is offline