Originally Posted by
sugelle
The bottom of your servo is hitting the chassis??? How would that fry the servos? I thought the as long as the EPA was set properly and you follow the instructions in the link to ensure no binding and a little room for chassis flex, everything was OK???
Something to do with the impact the case takes against the chassis plus it's going to be more susceptible to sustaining vibrations.
I always used spacers when I ran Ace servo's although on Savox at the mo, and they are not so deep, so don't need a spacer.
Managed to pick some new gears and shafts today, but not racing agin till the 14th.
Front and rear shafts had taken more wear than the centre, which wasn't so obvious, but had wear none the less