R/C Tech Forums - View Single Post - Futaba receiver question
Thread: Futaba receiver question
View Single Post
Old 06-04-2009 | 02:37 PM
  #20  
Ashley Cobb
Tech Elite
iTrader: (28)
 
Joined: Dec 2006
Posts: 3,156
From: Brisbane
Default
The only wires that need to go to the receiver are the signal and ground wires.

You make the ground into a Y harness and take the positive for the servo directly to the regulator.

A pos/neg will need to come out of the regulator and go to the receiver battery port as well.
Ashley Cobb is offline  
Reply