TC3 Arm Mount Question:
Do you modify your supension arm mount heights for carpet? Sorry if it has been asked on here and I missed it (tough at 400 posts strong). Basically are they stock, with washers added, or with material removed?
I'm going to try carpet soon and have heard tons of rumors about the "hot" setup with either raised or lowered mounts.
Also earlier, you had mentioned running a bit more droop in the left rear to compensate for the torque steer effect of the shaft platform. Is this an "automatic" setting you apply, or does this change depending on a conditions and equipment (like mod vs. stock)?
Thanks for helping us all out on here and best of luck at Cleveland!