Originally Posted by
penmark67
Clinton , Ive seen a Serpent S400 gear diff in a 416 it was a little odd though, I think it was a 36t pully and used different tooth pully's on either side of the centre shaft to keep the ratio the same
BUT it was really quick, i have'nt seen him since so the details are only guesswork from about 3 metre's away
Mark
I tried to put one in, i managed to find narrower 3mm wide bearings, and it fit all ok, but i could not find belts short enough for the rear end.
I did manage to fit it into my TOP Scythe, and it was awesome, sssssssoooooooo much punch, and never had to pull it apart.