Hey Guys,
Ran into a problem with my setup of clutch etc etc.... now for some dumb arse reason more likely me but i cant get any end float on the clutch to provide a good clutch setup.
Basically i am stumped, as i have added way over too many washers / shims etc and then when i tighten the bolt that goes into the crack it all goes tight and locks up the clutch...
I am running a OS TZ .12 - is the bolt that came with the mugen kit differ from engines to engines? do i need a differant collect for the flywheel or use the one in the kit?
Done clutches before but little bit stumped - anytips on the clutch setup, keep in mind i did use the manual to setup first but seems it doesnt like me!