Originally Posted by
Dummer40
Hey everyone. Couple of ?'s
I have a caster grenade engine. I've been told it's a go 5 port. Is this correct?
Are you guys running the go carb? If not what carb?
My motor has around 3/4 gallon on it and still extremely tight. I heat the block and head to 200 degrees before starting and make sure piston is down when finished. I sealed engine with sensor safe sealant.
Question is what temps should I expect?
Thanks for the answers.
I have never had one apart but I'm sure it's a 5 port. I have 3 different gen Go carbs with no problems with any. If it has the long low speed needle I would shorten it, the long lsn never comes all the way out at wot. (looking in the carb)
It is good you heat up the motor, it will help it last longer, on the 5 port it starts making good power around 240 deg. we run it up to 280 at times.
Rex