Originally Posted by
t4ftracer
anybody have the epoxy come out of the crank in to the crankcase on theirs? It just happened to me this weekend. Didn't do any damage cause it's like a soft silicone, but it plugged up my ports. Not sure if I can just clean it out and put it back together without the snot in there or is it a necessity for efficient operation?
Greg was that a fully modded? if so its part of the mod it helps out to flow better. I've heard a few that have had the same thing happen as long as you have nothing damaged you can re-fill it with devcon or JB weld in place. Make sure you clean it real good before hand.