R/C Tech Forums - View Single Post - Futaba receiver question
Thread: Futaba receiver question
View Single Post
Old 05-24-2009 | 10:11 PM
  #17  
MIke Clark's Avatar
MIke Clark
Tech Initiate
 
Joined: Jan 2008
Posts: 32
From: Hueytown, Alabama
Default
Originally Posted by jono0309
hey,

i am currently running a 3pm 2.4ghz with a R603FF, and Ive run it in my slash with great success, no overheating problems but now need another one, so will a R603FS work on the 3pm too?

Also because the slash has such a tiny radio box (since it only houses the reciever) does anybody think i'll have overheating problems? I reckon i should cut some plastic out the reciever casing as they are easy to open up.

Cheers.
Don't cut open that receiver box. Neither the FF or FS are conformally coated units. conformal coatings, if used it should protect the receiver from water or fuel intrusion.

The heating problems came form inside the receiver, voltage regulators! Not to worry about operational temps unless they get above 150 degrees.
MIke Clark is offline  
Reply