Originally Posted by
looper
to the top, when sending in the engine for pinching do i need to do anything in the way of prep to it or should i just send it as it sits?
Go 3 port sport question, when removing shims for 20% which one should i remove?
When sending the whole engine just send it dirty. I dissasemble and clean it first. I do get a little annoyed with people that leave clutches on, it takes more time to take that off than to dissasemble the motor. I have been pretty swamped , I came home from last weekends race with over 10 motors to rebuild. Plus I have a couple new Go 5 ports to mod.
On the 3 port sport for 20% I would remove both brass just use the aluminum.
Nick, I'll be watching for Uncle Fester dropping the motor off.
Rex