Hi, I recently purchased a DX3.0 radio and a sr3000 receiver. I hooked it up and everything and realized that the sr3000 only has one input for the steering servo and the e-maxx uses dual steering servos. So i bought a Y connector to solve this problem. Now when i use the DX3.0 I only get about 80% of the motion on the servos. Which hinders the the ability to take sharp turns. Ive fooled around with the settings on the controller for hours with no avail. I was wondering if someone could supply some much neeeded help.

Btw, when i connect the Stock tx/rx i get full range on the servo. Could it be that the servos are drawing to much power on that single input?