R/C Tech Forums - View Single Post - Tamiya TRF416 / TRF416WE / TRF416X
Thread: Tamiya TRF416 / TRF416WE / TRF416X
View Single Post
Old 05-18-2009, 12:27 PM
  #5444  
John St.Amant
Tech Master
iTrader: (1)
 
Join Date: Jul 2004
Location: MI
Posts: 1,544
Trader Rating: 1 (100%+)
Default
Originally Posted by Goingfast
.
There are two sets of holes at 90 degrees.
Problem is the cup gets elongated and beat to death by the drive shaft long before the pin holes wear out. But then usually only when using a spool.
John St.Amant is offline  
Reply