Originally Posted by
roadracer43
Houston/Monty,
My fuel inlet on my hsn is turned in a way that my fuel line is kinda kinked do to its position. The carb is turned as much as it can be. Its angled to the inside and away from the tank. Is there a way to turn the hsn any so it will face the other way ? Im thinking of sending it to you for a mod job but its only got 1 gallon on it. Should I wait until about 4 gallons so you can change the bearings/rod if need be ? I would rather someone with experience turn the hsn if it can be. Can you do this also ?
turning the fuel inlet banjo is fairly simple . use a 9/32 end wrench to loosen the hsn 'til it is just loose , rotate to desired position and retighten . do not overtighten but make sure it is snug . i dont recommend using pliers but it ups to you if you want your carb to be all scarred up
hope this helps ,
monty
just lmk when you need it done .