I have begun my build of the SC10, so far on page 4 of the build, I'm a bit slow on building my kits, so hopefully I should be done with it in a couple of days so I can start and prep the body for the paint.

It's been a while since I built a 2wd, my last one was five years ago with the FT B4. I truly miss building these 2wd, they are so much more simpler then a 4wd, which can be pretty tedious...

AE doesn't disappoint. Their kits are still the same, high-quality kits. I truly enjoy building their stuff.

Anyone have any "gotchas" that I should watch out for while building this thing?

Also, does anyone have a recommendation for what source of powerplant to put in this thing? I'm thinking of bringing out my old Novak GTX and run some brushed motors. I have a 27T Monster stock motor (revenge/return of monster was it?) and I also have a 12T modified from my brushed 4-wheeling, which was replaced by brushless...

I was thinking of getting another 4600Kv Mamba Max system for it. Is it too much motor for this kind of truck? The 4600Kv in my DF-03 runs awesome, but maybe too much for a 2wd truck with a lot less traction (gonna stick with the stock rubber for now)...

But my initial reaction was, the body for these SC style trucks are HUGE! I can fit my B44 underneath it!


Side Note:

FN Cuda, what days are you at OCRC? I'm interested in getting one of your brace as a preventative measure. If a good driver like you can break the chassis, might be worth it to prevent a chassis breakage... How much do you sell the brace for