Originally Posted by
91integrags
hey guys, i had purchased an eb modded trinity extech .24 tuned motor here on rctech recently. i had run the motor, motor cannot hold tune. the carb slide boot and possibly the o'ring on the slide is torn. oil and pressure is escaping in this area. i cannot find any parts for this motor (o'rins, boot, seals, etc.) online anywhere? does anyone know where i can find these parts? tried contacting teamtrinity. but no reply yet.
does anyone know if any other carb can fit on this motor?
i am very pleased with the motor, just needs a resealing. thanks
The siro carb boots are VERY thin/sensitive. I can almost guarantee your problem is a pin hole in the boot.. Very common problem with the siro based engines. take off the boot, clean it, then stretch the rubber with your fingers to find the hole. The smallest little hole will piss fuel when the engine is in HI RPM and the boot is ballooned under pressure.
PS use Lucky 7 engine sealant to seal up your engines.
http://carolinasrc.com/Webstore/Scri...idproduct=8845