Well, I think that the break in process is going well so far. I have used the heat gun to get it upto 185-190 between starts and have run 2.5 tanks through it. the LS is set at 4 turns (or .77mm in from flush) and HS at 3.5 turns (or .04mm in from flush) and it seems to be doing well. The temp are running between 205-235, normally right around 215-220. I have been driving it around the street at roughly 1%-25% throttle with littl bursts, but not into high rpm's. It runs and idles great, stalls every now and then when at idle and I do a little stab, as it comes beck to idle. I am sure that this is just part of the break in process though.
I can already tell that it will be a screamer and will get great mileage, it runs forever right now. I finally had to quit because I didn't want to piss te neighbors off!
Looks good though.