SMRACER,

I believe the problem is due to the break in procedure by EBMods. I was told he does the Full throttle super rich version of a breakin which is tough on the Rod / pin.

I have about 3.5 gallons on mine that I have sent back to Chad @ Trinity and we will see what they do. Before I sent it back I put a new rod in the motor and it still had way to much slop at tdc.

I have another .24 broken in by Chad and it runs flawlessly. Only one gallon on it but no problems thus far. It is one bad azzz motor.

All in all I think I will break in my motors myself from now on.

GLTY