Buggy Engine Will Not Fit
Ok there must be something I am doing wrong but I cannot figure it out.
I have a brad new Trinity Extech .21 engine for my new Losi 2.0 roller that will not come close to fitting.
After everything is mounted up, lined up and mesh set on the clutch bell to the spur gear my carb slide boot is smashed up against the center diff top plate. It seems that it is sitting to low and to far foward.
The only way I can get clearance is to twist the whole carb a 1/4 inch so that the high speed needle is sitting much lower that low speed which is bad news.
I am using the clutch wheel from the roller. I tried both the losi clutch and the trinity clutch. I even tried swapping out clutch bells on each set up and still wont fit.
Please help!!!!!!!!!!!!!!!!!!!!!!!!!