Hello guys,
there is a point I would like to share with you about my new GO 5ports Stock engine.

The temperature of the pipe is high, which means my bodies are melting on the area above the pipe.

Has anyone had this issue before ?

The configuration I'm using is:
25% nitro fuel
OS P7 medium plug
GO 2047 Pipe
OS 2060 header (a litle bit shorter than the GO header)
Shimm: 0,1mm less than the stock configuration
engine work temp: 239 - 248 F
Good top end - not so good botom end.

Is this a normal situation for a GO Engines or does anyone has any sugestion ?

Thank you very much.

Cestari