R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 04-21-2009 | 11:35 AM
  #6449  
mfrosty's Avatar
mfrosty
Tech Fanatic
iTrader: (14)
 
Joined: Jan 2009
Posts: 920
From: Baltimore
Default

Originally Posted by RETRO RC
Hey Grizz Frosty actually said to richen up the bottom end which is not what Tagalong needs to do.

It sounds like your HSN is lean and your lsn is rich and your idle is slightly high to compensate for the rich LSN

1. get your engine up to temp. atleast a tank

2. give your buggy a full throttle run away and back to you and bring it to a stop if the engine revs quite high then drops back to a normal idle after a about 5 -7 seconds you need to lean your low speed needle

3. continue doing this until the idle remains consistant after the WOT run and then adjust your Idle to suit. and fine tune the HSN.

hope this helps

Adrian
Sorry, I meant the other way around...........didn't mean to give you bad info.
mfrosty is offline