Originally Posted by
malik
Ok I have a mill out getting modded, the recommended pipe for this mill is an 086. Now the modder says that I should get either a 053, 2035, 1005, 2060 ect now because of what he is doing. I am by no means questioning him just want to hear your thoughts. The reason I chose the mill as my 2nd was that it used the same pipe that I am running on my current mill.
i personally dont like EXTREME modding as some people do , if they know what they are talking about and have real experience with their mods then you will notice the engine run properly , if it becomes a pain , make them buy their engine back
i would