R/C Tech Forums - View Single Post - New Yokomo TC, the BD-5
Thread: New Yokomo TC, the BD-5
View Single Post
Old 04-10-2009, 10:12 PM
  #389  
niznai
Tech Elite
 
niznai's Avatar
 
Join Date: Feb 2009
Location: All over the place
Posts: 2,974
Default
Originally Posted by fastolfart
RC Champ have been very helpful with relaying messages to and from Yokomo.
Though the issue has not been totally fixed yet, the problem lies in the motor mount area mounting to the lower deck. If you look at the photos, you can see a gap between the motor mount and the support brace which I filled witha 0.5mm shim. The lower screw hole does not line up with the chassis with the shim in place, but the top plate now fits perfect. The last photo shows the colour difference between the motor mount and the other parts
I am not sure I understand what the problem is.
From your pictures it looks like your .5 mm shim offsets the motor support brace towards the battery about the same amount. Why is there a problem then to just take the shim out? Or perhaps a thinner shim would solve the problem?
niznai is offline  
Reply