Originally Posted by
pakk
Correct, 0 timing on the motor because it is not adjustable AFAIK, its set to 0. I am currently @ 3.75 FDR because the motor recommends 3.8 and that is the closest I got. I do have a 5t smaller pinion. You are suggestion I be up around 4.1?
You're saying boost is stronger between 1-10 than 11-100? I'll go try.
--pakk
Originally Posted by
pakk
...
What I am saying is setting the boost to anything does not seem to do anything.
When timing changes, is it very noticeable?
--pakk
There is no boost 11-100, that would be timing when running in Dual mode. I have found dual mode to have less top end in any wind 10.5 and slower. If you have one of the more current versions software 189 or 194, check the box marked Sensored, the timing slider will change to Boost (0-30), if the motor is at 0, set boost to max, you should be a rocket then. Only run for a minute or so to start so to check motor temp.