Originally Posted by
JFCJ
I recieved my kit last week; and so far, it has went together flawlessly. I did some minor polishing and reaming, but nothing unexpected. The only challenge I've had so far is pressing the inserts in the rear carbon fiber for the upper arm pin. Their longer than the carbon fiber is wide. I don't want to take pliers and bugger up the insert... so I'm trying to find a outward press type tool for the job. Any suggestions would be appreciated. Those things are tight!
A friend and I just ust a soft material that was hollowed out a little and put over the hole and used a hammer and lightly tapped it through