Originally Posted by
or8ital
Yeah I pushed the bearing as far as it would go. It wasnt very much material (maybe .2mm) that I had to remove but it just wouldnt drop in cleanly. It was driving me crazy trying to figure it out. I tried to get it with just adjusting shims but it just wasn't moving the bearing enough to get the piece to drop in. I did switch out all my bearings for ceramic so there is a chance that bearing was slightly larger then the standard tamiya bearing depending on the QC of the bearings.
good to know if i ever get ceramics for this badboy.... what ceramics (brand) are you using?