View Single Post
Old 03-30-2009, 06:39 PM   #9
kvrc
Tech Master
 
kvrc's Avatar
 
Join Date: Oct 2003
Location: michigan
Posts: 1,000
Trader Rating: 10 (100%+)
Default

Quote:
Originally Posted by Dave H View Post
Got any brushed mod motors? Before brushless I put a stock armature in a modified can, so I could turn down the timing. Lower timing = a little less speed, much less heat, much less brush/comm wear, better runtime. The bearings help run time and maintenance too. And if itís not enough punch you can always do the same with a 19T or whatever arm.

Not nearly as good as a brushless, but perhaps a way to get the kid some run time at low cost without burning up every motor ya got.
yes i can do those things but i want to get away from brushed if possible and also run stock if possible. i guess i wont be able to do it with my mamba max so i am getting a tekin 632 and running 4 nickel cells when my boy drives it. i will just run mod if / when i race it.
kvrc is offline   Reply With Quote