Originally Posted by
Stanton
Aaron,
There was a bad batch of bearings. But, you also need to take out the side play in the rear axels. Use LOSB3951 13mm shims. $3.00 You will like these.
Mike Stanton
13mm shim's for the axle ? you need a 8mm shim for the axle hex's.
these are what you need for shimming the hex's.....i would recommend leaving a tick of play in them tho....as if you take up all the slop you will junk out bearings even faster.
http://www.amainhobbies.com/product_...oducts_id/4067