R/C Tech Forums - View Single Post - Xray NT1
Thread: Xray NT1
View Single Post
Old 03-21-2009 | 04:52 AM
  #3975  
aussies1129's Avatar
aussies1129
Tech Elite
iTrader: (74)
 
Joined: Jun 2007
Posts: 3,485
From: LAND DOWN UNDER
Default
Originally Posted by rcfoolz
To prevent this from happening agian, always turn the gear while sliding it onto the 2 speed shaft.
thanks for the good advice will definately do from now on.

foolz would you know the pin size that goes in the bearing I might get a few spare just in case??

cheers
Last edited by aussies1129; 03-21-2009 at 05:35 AM.
aussies1129 is offline  
Reply