Originally Posted by
mfrosty
Yea, I saw your FS thread, thanks but that's not enough engine for me. If I have to end up getting a new engine I'm definately going to just go ahead and get one from MM. I'll just have to try to pick up a few side jobs to make a little extra $$
No worries.. I just threw that out there. I started using them when I saw our local Xray sponsored driver runs them on club weekends, he puts in his high end mills only at the large points events. Not a bad way to save money, and watching him drive with a "low end" mill is impressive. A lot of people spend heaps on mills and never use a fraction of the power they offer. It's like a noob motorcycle rider on GSXR 1000. I've seen guys go through gallon after gallon on a $400 engine and never even get a proper tune on it.