R/C Tech Forums - View Single Post - Trinity Extech .24 stock needle settings
View Single Post
Old 03-05-2009, 09:40 AM
  #2  
Sholler
Tech Adept
iTrader: (1)
 
Join Date: Jan 2009
Location: Alexandria,KY.
Posts: 105
Trader Rating: 1 (100%+)
Default

If its modded then the stock settings will not help. I got the basic .24 2 weeks ago and had to fatten it up alot on LSN and the HSN. Do not quote me on this, but I believe the settings are 2 1/2 turns on LSN and 4 1/2 on the HSN. No where close to where i have mine set now. LSN is flush with the housing and the HSN is just under flush.

Runs best @ 190-210 degrees, anything over that and it starts to get erratic on the tune.

Once you get it tuned, It will run great!!

Almost too much power for a truggy, ALMOST!!

Hope this helps
Sholler is offline