R/C Tech Forums - View Single Post - Brushless Conversion easy?
View Single Post
Old 02-27-2009, 07:00 PM
  #13  
dangerwr
Tech Elite
iTrader: (5)
 
dangerwr's Avatar
 
Join Date: Sep 2008
Location: Boulder, CO
Posts: 2,245
Trader Rating: 5 (100%+)
Default

Originally Posted by NickT916

My goal is to basically have a good top of the line 1/8 scale buggy, but not worry about tunning, gas, plugs, and avoiding being to loud, while being able to just run about 30 minutes on one charge and being as fast as if it was on nitro... so 50-60mph range, i have seen brushless converted 1/8 buggies hit 80-90 on youtube. (im not sure what motor/gears id need to use to get the most out of the car, still learning) its beein some 5 years since i have owner an E-HPI.

please dont bash im a noobie
Well, we were all noobs once! I seriously doubt you will ever get 30-minutes on one charge regardless of your setup. Even 20-minutes takes research and a good amount of driving skill. Most guys gear their 1/8th brushless buggies at 45mph. There is no doubt that a brushless buggy can out perform any nitro if done properly. Good luck with your choices and refer to the 1/8th conversion thread if you have questions. Cheers!
dangerwr is offline