Save your time on your engines and improve your driving skill would be more practical than BS too much here......... beside you may post your engine pictures and offer everybody a lesson and tell how great you are. Here is very open, you may promote your good concept and business here anytime.

Every tuner has different theory and interpretation. An engine whether could run fast or run with “high torque” has been determined on the engine blue print and what material going to be used. Material is very important to engine performance too especially on piston and conrod. (I believe companies have similar concept and design nowadays.) Take a look the pistons on $100 and $400 engines if has chance next time. Everybody could tell the difference. Under the electronic microscope, everybody could tell the true inside story.

Modification is just a fine tuning on the engine since mass production may not have stable and consistent quality. I always want the engine run smoother than as stock rather go to be the fastest one. As everybody knew run faster mean the engine would consume more fuel and shorten the run time and shorten the life time.

You guys always mention about timing……… come on, don’t fool people around and people are not stupid here. (I also have a Mechanical Eng. degree and I was major in automobile and machine design field; and I am in manufacturing industry too.) Only a 0.00XX inches porting cutting would turn the engine become a Ferrari is hard to convince people……. If it is so simple, every engine company could have this done for you before putting into the packaging.

I do not produce engine and do not sell any engine here. I just show and share my joys to friends here. After I have modified 300s engines in past years, I have learnt a lot and knew what should do and what should not do.

However I knew you guys are jealous because you don’t know how to create a fancy engine. I don’t mind you guys keep on criticizing and I will post more pictures later and offer you more chance to have more acrimonious comments. Sounds good eh!