Originally Posted by Sholler

A couple quick questions for you guys. Just got a ET .24 base model and fired it up yesterday.After hearing it run for about 4 seconds i knew the needles were severely out of whack.Factory settings call for 2 1/2 on the LSN and 4 1/2 on the HSN. so i readjusted and it still seemed very lean, had to go another 2 full turns on the LSN, now it sits just a hair over flush. Same on the HSN. In doing this I noticed the motor is set just a hair on the rich side, top and bottom. Anyone else come across this yet? And it seems the LSN doesnt have much restriction on it, turns very easily. I am afraid with the motor vibration it will only turn itself and lean out unexpectedly. Any ideas to fix this little bug?

Im running byrons gen 2 25%, LRP #7 md-cold, and ofna 086 pipe.

All in all the motor seems like its gonna be stupid fast!!! I`m just trying to get some input so i can enjoy it for as long as possible.