Originally Posted by
Slapmaster6000
I would look for at least 20 ounces. This is a popular question. The JR3650, Futaba 9650 & the KO946(?) have been mainstay servos. One thing I really like about the JR servo is that fact you can fine tune the center mechanically with a thin blade screw driver through the spline hole. Just be gentle, it's the pot after all!
Amazing that I had never heard about that before. I had been strugling to find out why my travel adjustment was off so much that I had to have the end point at 100% to the right and only 30% to the left. All the tie rods were the same length, servo saver good, etc. I pulled the servo saver, reset the center point on the transmiter and the adjusted the center point on the servo with that lilttle screw and WHAM! I now had to readjust the end points to where they are now only 5% different. Simply amazing! Thanks for the tip.