Originally Posted by
J-DUB
yes. they are a much tighter fit on the side to side play. we also took some of the runout out of the front bearing the injection mold left .005 to .006 run out and now there is about 2 to 3. i am doing spindles just for the simple fact of buying 1 size outer bearing and that even the front bearings were locking up not blown yet, but on there way out the door for sure. thanks again tix for the tip.
The other thing i have been doing is running a 13mm drill bit through when im done. this just opens up the inside of the hub abit more to avoid it rubbing the bearing seal
Ill have to give the spindals a go. ive never bothered because ive never blown one and ive still got heaps of spairs from when i was blowing the rears