R/C Tech Forums - View Single Post - Trinity Pulse motor
Thread: Trinity Pulse motor
View Single Post
Old 02-18-2009, 03:40 PM
  #21  
RC_Dan
Tech Regular
iTrader: (2)
 
RC_Dan's Avatar
 
Join Date: Aug 2006
Location: Ft. Collins, CO
Posts: 478
Trader Rating: 2 (100%+)
Default
Originally Posted by Drift Demon
Thanks for all the feedback guys, maybe you may also be able to help again. Ive found that Br00d is selling blueprinted versions of the pulse. & also, Putnam is selling blueprinted & tuned versions. would it be wise to grab one of these, or a 'raw' one?

I will be using this motor with my mamba max, if the two dont go together so well, then so be it, but has anyone here had any experience with these & a sensorless esc?
Previous experience with a MM and a Novak motor was that the gearing is totally different. Keep that in mind and check motor temps frequently until you find the sweet spot for your setup. I would start several teeth lower than you think you should, monitor temps/performance and go from there.
RC_Dan is offline  
Reply