R/C Tech Forums - View Single Post - motor breakin!
Thread: motor breakin!
View Single Post
Old 10-10-2003, 06:42 PM
  #8  
popsracer
Tech Elite
 
popsracer's Avatar
 
Join Date: Oct 2002
Location: "Hot, Sunny Southern California"
Posts: 3,120
Default Motor break-in!

Guys;

I too have read (maybe in a Magazine) the RE-cut the Com after break-in thing somewhere, so 'holycow' is not just making this up on his own. I tried it once or twice based on that article, and saw no performance benefits in doing so.

Using a sharp Lathe Bit, then a few minutes of break-in at low voltage (3-4v) with no load, Should have little effect on Com concentricity (trueness), in my opinion.
popsracer is offline