Originally Posted by
trout74
Danny,
thanks for considering!
The dimensions with the pads in place are as follows:
143X48X33 mm. I could remove the pads and it would add about 2 mm but its minimal. Take your time and see what you could make, and if its even economically feasable for you to make a custome pack, you have to make money too. But I bet you would sell a bunch to the AE guys.
thanks again,
Trout
Thanks for the dimensions but I wonder how these dimensions are possible if AE uses 2 of there 2S hardcase packs. This means the packs fit on the side and the height will be 47mm and the width will be 50mm and the length 139mm
http://aedownloads.com/press/in_012309_rc8ftle.pdf