Hmm, decreasing cell count is going to increase current draw. Put it this way - it's about power output in the end. Simply put :
Power = Voltage X Current
To produce the same power with lesser voltage, more current is needed & vice versa.
More current results in more wasted heat due to resistance in the system.
So, higher voltage setups tends run cooler & longer for the same capacity of power source (battery)
Originally Posted by
Frost
hmm... (I think laa....) to prevent your motor from overamped....
one way is to increase resistance, perhaps by increasing the pinion size to about 16-17T ?
another way is to reduce the voltage, use lower S count Lipo battery.
Or control Tx throttle curve
Or use a smaller ESC, and give that MMM ESC to me
Regards,
Joe Ling
PS : Frost, Feigao cahrt as attached