R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 01-29-2009 | 09:02 PM
  #5498  
22Racer's Avatar
22Racer
Tech Elite
iTrader: (67)
 
Joined: Mar 2002
Posts: 3,150
From: Wanamingo Mn
Default
Originally Posted by jeremy reed
I just purchased the go .21 3 port sport engine. I'm newer to nitro so want to stick to basic spec type 3 port motors for now. Do they stay tuned pretty well? Also when I crank it for the first time,will the needle settings be fairly close?I have an rd logics .21 that is running really well and have finished well with it cause I can control it and everyone else is way over powered. I also have a sportwerks .26 that the settings were not even close. Just wondering how close the factory settings were at initial break in. Thanks for all your help

They are usually pretty close. I am not sure on the aluminum sport carb what exact settings are. If it is similar to the plastic carb it should be flush on the high speed and 1.5 turns in from flush on the low speed.

Rex
22Racer is offline  
Reply