Some guys tried it on the regular TA05, but I haven't seen anything about it with the TA05MS. You can see it by searching the part number (1004) on Tamiya USA. David Jun Pro module suspension is made of aluminum; I'd be worried about bending the expensive A-arms. Furthermore, I don't think it was intended to be used with the short lightweight arms. The MS has impressive cornering with the short lightweight arms though I don't know if the short arms provide more high speed stability. The power from the 10.5 I have been using with my TA05MS hasn't given me any rear traction issues.
I found time to do a little testing with my TA05MS at the local track today and ended up making a small change to the rear roll center from the setup that I last posted. It worked out well and when I go back to the track tomorrow, I am going to try a stiffer front sway bar in attempts to find a little more braking traction.