View Single Post
Old 01-04-2009, 10:28 PM   #2
Tech Addict
Join Date: Sep 2008
Location: Marble Falls, Texas
Posts: 525
Trader Rating: 3 (100%+)

If you are tightening the screw and the bell gets to where it wont turn, your not shimmed right. Read the owners manual for proper guidelines for shimming. THe screw should be tight, and ther should be a shims worth of end play and the bell should spin freely. You tightening on the race of the bearing and binding it up. U ran it loose to keep the bell spinning but thats why they bell fell off. IMO!?!?
Clay Grantham
TLR 8ight 3.0/Futaba 4PLS/WERKS B5 .21/VP Fuels
motoclay is offline   Reply With Quote