i have the .24 eb mod pre run i am running trinity plat 30% and a p4 plug. i haven't moved the settings on the carb hsn a 3/4 above flush and lsn flush and idle 1.25 mm, JP-3 pipe. This is my third tank in this engine.

the tank is my third and is brand new lol, i have another brand new tank i will try. i did a leak test on the tank and came up with nothing. i submerged it in water and blew in the pressure nipple and closed off the fuel outlet nipple. i blew as hard as i could(lol) and no air bubbles. i used a high power light and could not see a crack or anything? i have tried new fuel line twice. it definately has air bubbles a lot of them at times at this level of fuel in the tank. under idle the bubbles dissapear but after a high speed pass there back.

you guys sure the fuel level just isn't too low?

I have pulled both the nipples(lol) and CA'd the threads and will try again tomorrow.