Originally Posted by
Clegg
So something I am noticing, one of the larger issues running LiPo in the BMI chassis, is with the lack of any cell holder/adjuster in the car, the LiPo cell is quite likely to come into contact with the flex bars. This could cause the car to drive like its tweaked if its held up by the LiPo pack.
Not sure if the tape hold down method would address this, it just seems quite easy for the pack to come into contact with the bars. Any ideas?
I made some aluminum tabs to position the battery front to back. I noticed the side to side movement, so I'm working some that will help with that too. If we're lucky, Jason has some of these batteries and is working on a set made out of brass. That way we can locate the battery and put on a little extra weight.