R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 09-25-2003 | 02:19 PM
  #4102  
DPowell's Avatar
DPowell
Tech Regular
iTrader: (3)
 
Joined: Apr 2003
Posts: 454
From: Denver, CO
Default Re: Drilling/Sanding Graphite Chassis
Originally posted by Bobby Z
DPowell

I picked up a countersink bit and was wondering what type of respirator should I purchase to protect my lungs when drilling/sanding graphite? I am concerned about inhaling any of the dust particles and would prefer to be safer than sorry. Are the hardware store variety $3 masks safe enough or should I invest in something safer than that?

Thanks

Bob
Bob,
For just a couple holes, a $3 particle mask should be fine.

D.P.
DPowell is offline  
Reply