R/C Tech Forums - View Single Post - Comm Turning Question
Thread
:
Comm Turning Question
View Single Post
09-17-2003, 05:49 AM
#
2
che
Tech Regular
Join Date: Aug 2001
Location: Niagara Falls, Ontario
Posts: 291
Trader Rating
: 0
If you can, change the timing on the stock motor to '0' (zero) degrees, and then keep the voltage under 5v for running the lathe. You may have to play with the voltage to find the best results, depending upon bit condition, etc.
Reply
che
View Public Profile
Visit che's homepage!
Find More Posts by che
View iTrader Profile