I just got a 7 port in my D8 with a 053 mid range pipe from Dynamite
I have read a lot of posts that were talking about the carb settings
This is my first Go engine and the HSN and LSN are both flushed out
I tried leaning it in like an OS but no fuel was going in
I have noted that it just needs a few adjustments and looking at how the needles flush is not so helpfull
This engine has alot of pinch and is difficult to break in via heat cycle
I have a few tanks on it and it looks like it is a very good engine for my D8

Anyone have needles settings with the 053 mid range dynamite pipe
Looks like I will be happy with this motor just as long as I dont make it too lean
Thanks