Originally Posted by
BIGBOT
Thanks I have a brushless system on the way that I was going to put in another car but now I think I will try it in my 1/12
Hopefully it's one of the 4-cell GTB's though. If it's a 6-cell GTB even if you remove the fan the heat sink is too tall to run with modern 1/12 bodies. I've seen some folks cut out an aluminum plate (like the 4-cell GTB) to replace the heat sink with. I've also seen folks mill the heat sink down flat.
GTB/10.5 in a 3.2R is hard to beat for fast-n-fun on a budget!!